Look out "BELOW"

Ask other modelers for a little help / knowledge ?

Look out "BELOW"

Postby cliffm » Tue Sep 13, 2011 11:08 am

The below I'm refering too is below freezing. I keep a lot of my spray paints, paints, glues, cements,gasket sealers , and some other things affected by freezing out in my unheated garage and if they don't get put in the house or somewhere heated most of them will be ruined. A lot of you live in the banana belt so not to worry,but for us folk in the upper paralels fall comes with those nice frosty mornings. Just thought I might save someone a few bucks as I found out the hard way, later.
cliffm
 
Posts: 370
Joined: Fri Feb 27, 2009 11:08 am
Location: fairdale N D

Postby BillParker » Tue Sep 13, 2011 2:06 pm

you oughtta see good good spray paint comes out of the can at 107 degrees fahrenheit.




:twisted:
William H. Parker Jr. (Bill Parker)
President, Parker Information Resources
http://www.parkerinfo.com/ap.htm bparker@parkerinfo.com
BillParker
 
Posts: 1031
Joined: Sat Jan 19, 2008 1:21 pm
Location: Houston, Texas

Postby Dusty » Thu Sep 22, 2011 10:04 pm

Funny how just up from where cliffm is it can be 45 below in winter and 110 in the summer, paint does atomize really well when it's nice and toasty! In the winter you might have to put your car battery in the house, never mind spray paint.
There can never be too many stringers
Dusty
 
Posts: 25
Joined: Sun Aug 28, 2011 4:48 pm
Location: Canada

krylon

Postby peterc4 » Fri Sep 23, 2011 9:06 am

I use the clear Krylon outside in the winter. Not when its 10 below, but if there is a sunny day and the can has been inside(warm) it sprays ok - a lot of the voc's evaporate off if you leave the project outside for a couple of hours, but you do need to bring your project into the house to warm up a bit for the Krylon to fully set. It gives off a bit of smell, but much much less.

It aint a perfect system, but if you get a bad case of cabin fever in Feb...
peterc4
 
Posts: 28
Joined: Thu Aug 27, 2009 3:40 pm


Return to General Building Questions

Who is online

Users browsing this forum: Bing [Bot] and 11 guests